Juniper JN0-682 Exam Practice Questions (P. 4)
- Full Access (97 questions)
- Six months of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #16
You have a data center design with multiple tenants using routing instances.
In this scenario, what are two ways to provide inter-tenant communications? (Choose two.)
In this scenario, what are two ways to provide inter-tenant communications? (Choose two.)
- AUse EVPN type-7/8 routes.
- BUse RIB groups.
- CUse filter-based forwarding.
- DUse EVPN type-6 routes.
Correct Answer:
AD
AD
send
light_mode
delete
Question #17
You have successfully deployed an IP fabric in your data center. However, your server team complains that they are not seeing an increase in performance as expected. After examining the routing and forwarding tables, you notice that only a single route is listed to each destination in the forwarding table, even though there are multiple routes shown in the routing table.
In this scenario, what should you do to solve the problem?
In this scenario, what should you do to solve the problem?
- AWrite a load balancing policy and apply it to the routing table.
- BModify the hash algorithm so that only source and destination addresses are used.
- CWrite a load balancing policy and apply it to the forwarding table.
- DDisable the Spanning Tree Protocol that is blocking the redundant paths.
Correct Answer:
C
C
send
light_mode
delete
Question #18
Which three statements are correct about multitenancy in a Junos EVPN environment? (Choose three.)
- AMAC-VRF instances allow for overlapping routes and VLANs.Most Voted
- BMAC-VRF instances allow for varying EVPN services on the same device.
- CVRF instances allow for overlapping subnets.Most Voted
- DVirtual switch instances allow for varying EVPN services on the same device.Most Voted
- EVirtual switch instances allow for overlapping VLANs.
Correct Answer:
BDE
BDE
send
light_mode
delete
Question #19
You are asked to implement a monitoring and telemetry solution for the QFX Series devices in your IP fabric that uses a push model to collect both system event data and statistical data for your QFX Series devices.
Which technology satisfies your requirements?
Which technology satisfies your requirements?
send
light_mode
delete
Question #20

Referring to the exhibit, you have a data center in which only the spine devices are using EVPN and VXLAN. The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.
In this scenario, which command configured on which nodes would solve this problem?
- Athe set protocols evpn no-core-isolation command on the spine nodes
- Bthe set protocols evpn no-core-isolation command on the leaf nodes
- Cthe disable protocols evpn no-core-isolation command on the spine nodes
- Dthe disable protocols evpn no-core-isolation command on the leaf nodes
Correct Answer:
A
A
send
light_mode
delete
All Pages