Juniper JN0-682 Exam Practice Questions (P. 3)
- Full Access (97 questions)
- Six months of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #11
Which IP fabric underlay protocol provides the highest degree of scalability?
send
light_mode
delete
Question #12
You are asked to increase the overall throughput of an existing IP fabric.
Which two tasks would accomplish this goal? (Choose two.)
Which two tasks would accomplish this goal? (Choose two.)
- AAdd one more leaf node to the fabric.
- BAdd one uplink to all existing spine nodes from the newly added leaf node.
- CAdd one more uplink from each leaf node to the newly-added spine node.
- DAdd one more spine node to the fabric.
Correct Answer:
AD
AD
send
light_mode
delete
Question #13
You have a two spine and a four leaf CRB topology and you want to ensure the hosts connected to the leaf devices have reachability to all local spine IRB interface addresses.
Which configuration parameters must be used to accomplish this task?
Which configuration parameters must be used to accomplish this task?
- AConfigure proxy-macip-advertisement under the IRB interface.
- BConfigure a spine-to-spine EVPN peering as part of the routing instance.
- CConfigure a spine-to-spine BGP peering as part of the overlay.
- DConfigure virtual-gateway-accept-data under the IRB interface.Most Voted
Correct Answer:
C
C
send
light_mode
delete
Question #14
You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1's VRF-1 to its INSPECT-VRF, however, the traffic is not reaching service L2.

Referring to the exhibit, which two steps should you take to troubleshoot the problem? (Choose two.)

Referring to the exhibit, which two steps should you take to troubleshoot the problem? (Choose two.)
- AEnsure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.
- BEnsure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT-VRF of L2.
- CExamine the INSPECT-VRF.inet.0 route table on L1 for a default route that will direct the traffic to L2.
- DExamine the INSPECT-VRF.evpn.0 route table on L1 for a default route that will direct the traffic to L2.
Correct Answer:
AB
AB
send
light_mode
delete
Question #15

A VXLAN has been created between devices leaf1 and leaf3.
Referring to the exhibit, which statement is true?
- ATraffic sent from host1 to host2 will be tagged with VLAN ID 200 when exiting leaf3.
- BTraffic sent from host1 to host2 will be dropped on leaf1.Most Voted
- CTraffic sent from host1 to host2 will be dropped on leaf3.
- DTraffic sent from host1 to host2 will be tagged with VLAN ID 100 when exiting leaf3.
Correct Answer:
D
D
send
light_mode
delete
All Pages