Huawei H12-811 Exam Practice Questions (P. 4)
- Full Access (417 questions)
- Six months of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #31
An AC is a unified management and control device in the AC + Fit AP architecture. Which of the following functions is not supported by the AC?
- AUser access control
- BAP configuration delivery
- CUser access authentication
- DUser data packet forwarding regardless of the data forwarding modeMost Voted
Correct Answer:
C
C
send
light_mode
delete
Question #32
In a broadcast address, all host bits are set to 1 and a broadcast address can be used as a host address.
send
light_mode
delete
Question #33
Which of the following IEEE 802.11 standards supports the 2.4 GHz frequency band only?
send
light_mode
delete
Question #34
The network Management Station uses SNMP to manage devices, which SNMP message is sent when an SNMP registered abnormal event occurs?
send
light_mode
delete
Question #35
The controller is the core component of SDN and connects to devices through southbound interfaces. Which of the following are southbound protocols used by the controller? (Choose two.)
send
light_mode
delete
Question #36
When both ends running PPP protocol detect that the physical link is active, the link state will transit from dead to establish. Which of the following protocols is used to negotiate the link parameters during this phase?
send
light_mode
delete
Question #37
Which of the following application-layer protocols are based on TCP?
send
light_mode
delete
Question #38
Which of the following is not an open API of Huawei controllers?
send
light_mode
delete
Question #39
Which of the following fields are included in an MPLS header? (Choose three.)
send
light_mode
delete
Question #40
Which of the following statements regarding the router ID in OSPF are incorrect?
- AThe router IDs of OSPF routers in the same area must be the same, but can be different in different areas.Most Voted
- BThe router ID must be the IP address of an OSPF router interface.
- CThe router ID must be configured manually.
- DA router running OSPF must have a router ID for it to operate properly.
Correct Answer:
C
C
send
light_mode
delete
All Pages