Nest 0 Cart
Nest Account
Popular Exams
All Categories...
Nest
Nest 0
Contact
Log In / Sign Up
Copyright 2024 © store. All rights reserved.
Home Cisco® 300-615

Cisco® 300-615 Exam Practice Questions (P. 1)

  • Full Access (247 questions)
  • Six months of Premium Access
  • Access to one million comments
  • Seamless ChatGPT Integration
  • Ability to download PDF files
  • Anki Flashcard files for revision
  • No Captcha & No AdSense
  • Advanced Exam Configuration
Get Contributor Access
Question #1
A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue?
(Choose two.)
  1. A
    Configure the NVE interfaces to be Up on both switches.
  2. B
    Set a different distributed gateway virtual MAC address.
  3. C
    Set a different secondary IP addresses on NVE source-interface.
  4. D
    Configure the same VNI to multicast group maping.
  5. E
    Set a different primary IP addresses on NVE source-interface.

Correct Answer:
AD

Question #2
A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Cisco Nexus
7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?
  1. A
    Use route map to statically advertise this MAC and redistribute with IS-IS.
  2. B
    Unknown unicast flooding is not allowed.
  3. C
    Use the otv flood mac <> command to selectively flood traffic for a given MAC.
  4. D
    Use the otv isis bfd <> command to configure BFD protocol.

Correct Answer:
B

Question #3

Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A?
(Choose two.)
  1. A
    Configure the local vPC role priority to have a lower value than Switch-A.
  2. B
    Configure the local vPC role priority to have a higher value than Switch-A.
  3. C
    Disable and then re-enable the vPC peer-keepalive link.
  4. D
    Configure the local vPC role priority to have the same value as Switch-A.
  5. E
    Disable and then re-enable the vPC peer link.

Correct Answer:
BE

Question #4

Refer to the exhibit. An OSPF adjacency between Router-A and Router-B fails to reach the FULL state. Which action resolves the issue?
  1. A
    Adjust the MTU on Router-A to 1600.
  2. B
    Disable the check of the MTU value.
  3. C
    Set the OSPF media type to point-to-point.
  4. D
    Adjust the MTU on Router-B to 1604.

Correct Answer:
B

Question #5
The Cisco Nexus switch is connected to a peer switch that is not running Cisco NX-OS. The switches are connected using port channel and are experiencing packet loss. Which action should be performed on the Cisco Nexus switch ports to resolve this issue?
  1. A
    Turn on lacp suspend-individual.
  2. B
    Turn on lacp graceful-convergence.
  3. C
    Turn off lacp graceful-convergence.
  4. D
    Turn off lacp suspend-individual.

Correct Answer:
C

Next Questions

All Pages