Nest 0 Cart
Nest Account
Popular Exams
All Categories...
Nest
Nest 0
Contact
Log In / Sign Up
Copyright 2024 © store. All rights reserved.
Home Cisco® 200-401

Cisco® 200-401 Exam Practice Questions (P. 4)

  • Full Access (64 questions)
  • Six months of Premium Access
  • Access to one million comments
  • Seamless ChatGPT Integration
  • Ability to download PDF files
  • Anki Flashcard files for revision
  • No Captcha & No AdSense
  • Advanced Exam Configuration
Get Contributor Access
Question #16
Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?
  1. A
    Switch(config-if)#
  2. B
    Switch(config-if-ind)#
  3. C
    Switch(config-line)#
  4. D
    Switch(config-ind)#
  5. E
    Switch(config-vlan)#

Correct Answer:
A

Question #17
What are the two most relevant factors in determining the class of administration that is required to maintain the telecommunications infrastructure? (Choose two.)
  1. A
    the size of the infrastructure
  2. B
    the complexity of the infrastructure
  3. C
    the age of the infrastructure
  4. D
    the industry that the infrastructure supports
  5. E
    the physical environment of the infrastructure

Correct Answer:
AB

Question #18
According to the Purdue Reference Model, at which layer would you perform manufacturing operations and control?
  1. A
    Level 0
  2. B
    Level 1
  3. C
    Level 2
  4. D
    Level 3
  5. E
    Level 4

Correct Answer:
D

Question #19
An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?
  1. A
    Enable port security and use the keyword sticky.
  2. B
    Set the switchport mode to trunk and save the running configuration.
  3. C
    Use the switchport protected command to have the MAC addresses added to the configuration.
  4. D
    Use the no switchport port-security command to allow MAC addresses to be added to the configuration.

Correct Answer:
A

Question #20
Exhibit:

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?
  1. A
    These commands need to be added to the configuration:C-router(config)# router eigrp 123C- router(config-router)# network 172.19.0.0
  2. B
    These commands need to be added to the configuration:C-router(config)# router ospf 1C- router(config-router)# network 172.19.0.0 0.0.3.255 area 0
  3. C
    These commands need to be added to the configuration:C-router(config)# router ripC-router(config- router)# network 172.19.0.0
  4. D
    No further routing configuration is required.

Correct Answer:
D

Previous Questions Next Questions

All Pages