Nest 0 Cart
Nest Account
Popular Exams
All Categories...
Nest
Nest 0
Contact
Log In / Sign Up
Copyright 2024 © store. All rights reserved.
Home Cisco® 200-401

Cisco® 200-401 Exam Practice Questions (P. 2)

  • Full Access (64 questions)
  • Six months of Premium Access
  • Access to one million comments
  • Seamless ChatGPT Integration
  • Ability to download PDF files
  • Anki Flashcard files for revision
  • No Captcha & No AdSense
  • Advanced Exam Configuration
Get Contributor Access
Question #6
Exhibit:

Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)
  1. A
    The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.
  2. B
    EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.
  3. C
    CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
  4. D
    EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
  5. E
    Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
  6. F
    IEEE1588 and PTP are important for ensuring real-time synchronization.

Correct Answer:
ADF

Question #7
Exhibit:

Which two statements are correct for a safe wiring installation to the terminal block of the switch or endpoint? (Choose two.)
  1. A
    Insert a green ground wire into the terminal block that is marked RT for return.
  2. B
    Verify that DC power is live and within 24 VDC voltage range before starting wiring.
  3. C
    Verify that the DC power circuit includes an overcurrent protective device that limits the DC current to 5 A.
  4. D
    Because this is a low-voltage DC circuit, anyone can install this wiring without electrical training or qualifications.
  5. E
    Connect the positive 24 VDC conductor to the V terminal and connect the negative 24 VDC return wire to the RT terminal.
  6. F
    A ground wire can optionally be connected to the screw terminal on the front of the switch.

Correct Answer:
CE

Question #8
What are two benefits of a star network topology? (Choose two.)
  1. A
    Disruption of the entire network is not required when adding new machines.
  2. B
    Any problem which leaves the network inoperable can be traced to the central hub.
  3. C
    This network type requires less cable as compared to linear bus topology.
  4. D
    The performance of one of the numerous nodes cannot reflect on the performance of other nodes.
  5. E
    The performance of the entire network is directly dependent on the performance of the hub.

Correct Answer:
AB

Question #9
Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)
  1. A
    designated ports
  2. B
    duplex operating mode
  3. C
    fast mode ports
  4. D
    root bridge
  5. E
    root ports
  6. F
    BDPU priority

Correct Answer:
ADE

Question #10
What is the purpose of Spanning Tree Protocol?
  1. A
    to prevent routing loops
  2. B
    to create a default route
  3. C
    to provide multiple gateways for hosts
  4. D
    to maintain a loop-free Layer 2 network topology
  5. E
    to enhance the functions of SNMP

Correct Answer:
D

Previous Questions Next Questions

All Pages