Nest 0 Cart
Nest Account
Popular Exams
All Categories...
Nest
Nest 0
Contact
Log In / Sign Up
Copyright 2024 © store. All rights reserved.
Home Oracle 1z0-404

Oracle 1z0-404 Exam Practice Questions (P. 3)

  • Full Access (70 questions)
  • Six months of Premium Access
  • Access to one million comments
  • Seamless ChatGPT Integration
  • Ability to download PDF files
  • Anki Flashcard files for revision
  • No Captcha & No AdSense
  • Advanced Exam Configuration
Get Contributor Access
Question #11
When setting up the registration-caching parameter to enabled in the sip-interface configuration element, _____________.
  1. A
    the Session Border Controller will never use the SIP-NAT mechanism for routing
  2. B
    the Session Border Controller will not use the registration cache for routing
  3. C
    all endpoints in the realm will be cached when registered
  4. D
    only endpoints behind NAT in the realm will be cached when registered
  5. E
    the Session Border Controller will never use the local-policy mechanism for routing

Correct Answer:
A

Question #12
What is the effect of executing the save-config command in superuser mode?
  1. A
    The running configuration version is reset to 1.
  2. B
    The running configuration version does not increase and is equal to the saved configuration version.
  3. C
    The saved configuration version increases by 1 and is higher than the running configuration version.
  4. D
    The running configuration version increases by 1 and is higher than the saved configuration version.
  5. E
    The editing configuration version increases by 1 and is higher than the saved configuration version.

Correct Answer:
C

Question #13
You are configuring a network interface to enable the Session Border Controller to use the interface for signaling and media.
Identify two valid configuration steps for supporting VLAN 12 (Choose two.)
  1. A
    Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.
  2. B
    Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.
  3. C
    Navigate to the phy-interface configuration element and configure the hip-id parameter.
  4. D
    Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.
  5. E
    Navigate to the network-interface configuration element and configure the name parameter.

Correct Answer:
AC

Question #14
You are examining a SIP packet. There is no final response to the ACK method.
What is the reason for this?
  1. A
    The ACK method was defined only in RFC 2543 and it has been deprecated.
  2. B
    The ACK method is part of the INVITE transaction.
  3. C
    The ACK method is an exception in RFC 3261.
  4. D
    The ACK method is an optional SIP method.
  5. E
    The ACK method was replaced with the CANCEL method in RFC 3261.

Correct Answer:
B

Question #15
View the Exhibit.

Which statement is true about this output of the show health command?
  1. A
    The two nodes have different health scores.
  2. B
    The training1 peer is the standby node.
  3. C
    The switchover berpd force command was executed to do a manual failover.
  4. D
    The training6 peer is the active node.
  5. E
    The training6 peer will wait 1050 ms before considering the training1 peer out of service.

Correct Answer:
E

Previous Questions Next Questions

All Pages