Juniper JN0-681 Exam Practice Questions (P. 4)
- Full Access (65 questions)
- Six months of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #16
After configuring an IP fabric using EBGP as your routing protocol, you notice that not all of the routes are showing up in the routing tables. You have verified that all adjacencies have formed, and that all policies are in place and configured properly.
In this scenario, which statement is true?
In this scenario, which statement is true?
- AThe routers have not been configured with the multipath multiple-as parameter.Most Voted
- BThe routers have not been configured using the add-path parameter.
- CThe routers have not been configured using the bfd-liveness-detection parameter.
- DThe routers have not been configured using the multihop parameter.
Correct Answer:
D
D
send
light_mode
delete
Question #17
Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A
VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?
VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?
- AThe service provider WAN connection cannot be an MPLS-based WAN connection.
- BVXLAN Layer 3 gateway must be provisioned at the Super Spine layer.
- CA route to the loopback address on VTEP2 must be present on VTEP1.
- DVTEP1 and VTEP2 must peer using IBGP.
Correct Answer:
C
C
send
light_mode
delete
Question #18
You are designing an EBGP IP fabric for a multi-site data center.
In this scenario, which two statements are true? (Choose two.)
In this scenario, which two statements are true? (Choose two.)
- APublic AS numbers must be used.
- BDifferent AS numbers should be used on all devices.
- CThe same AS number should be used on all devices across all data centers.
- DPrivate AS numbers can be used.
Correct Answer:
BD
BD
send
light_mode
delete
Question #19
An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. Host1 is a bare metal server, and is dual-homed to the network. The IP addresses 10.1.1.1/24 and 10.1.1.2/24 are assigned to the same physical NIC, and no virtualization is configured on the server.

In this scenario, which two statements are true? (Choose two.)

In this scenario, which two statements are true? (Choose two.)
- AThe MAC address associated with 10.1.1.1/24 and 10.1.1.2/24 will be the same when advertised to leaf3.
- BThe connection from host1 to devices leaf1 and leaf2 must be configured as a LAG.Most Voted
- CTraffic from IP address 10.1.1.1/24 must traverse the VXLAN network to reach IP address 10.1.1.2/24.
- DThe ESI assigned to the leaf1-host1 link must be the same as the ESI assigned to the leaf2-hostl link.Most Voted
Correct Answer:
BD
BD
send
light_mode
delete
Question #20
You are implementing perimeter security for your data center. You need to inspect all traffic at Layer 7 and ensure the failure of a port or device will not result in an interruption to traffic flows.
In this scenario, which design would satisfy these requirements?
In this scenario, which design would satisfy these requirements?
- ASRX using LAG
- BMX with MC-LAG
- CQFX Virtual Chassis
- DSRX chassis cluster
Correct Answer:
D
D
send
light_mode
delete
All Pages