Juniper JN0-360 Exam Practice Questions (P. 5)
- Full Access (477 questions)
- Six months of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #41
Which two statements correctly describe how the AS path attribute is used by BGP? (Choose two.)
- AThe AS path attribute is updated whenever an EBGP-learned route is re-advertised using IBGP.
- BThe AS path attribute is updated in EBGP advertisements only and is the primary loop-avoidance mechanism for BGP.
- CWhen local preference is the same, the AS path attribute is a common tiebreaker, where paths with fewer AS hops are preferred.
- DWhen local preference is the same, the AS path attribute is a common tiebreaker, where paths with more AS hops are preferred.
Correct Answer:
BC
BC
send
light_mode
delete
Question #42
Which statement describes the role of local preference in the BGP route selection process?
- ALocal preference is evaluated early in the BGP route selection process and results in the route with the highest numerical local preference being selected.
- BLocal preference is evaluated early in the BGP route selection process and results in the route with the lowest numerical local preference being selected.
- CLocal preference is used to break ties when all other received BGP attributes are otherwise equal.
- DLocal preference is sent by an EBGP speaker to a neighboring AS in an attempt to influence how the remote peer's traffic will ingress into your network.
Correct Answer:
A
A
send
light_mode
delete
Question #43
Which three BGP attributes are used for loop prevention? (Choose three.)
send
light_mode
delete
Question #44
You are attempting to influence return traffic into your autonomous system by preferring one router as an entry point.
Which two BGP attributes will affect this behavior? (Choose two.)
Which two BGP attributes will affect this behavior? (Choose two.)
send
light_mode
delete
Question #45
Which three BGP attributes must be sent to EBGP peers? (Choose three.)
send
light_mode
delete
Question #46
What is a valid BGP neighbor state?
send
light_mode
delete
Question #47
Which statement is true regarding BGP?
- AUsing BGP within your AS eliminates the need for an IGP.
- BEBGP sessions have a TTL value of 64 by default.
- CIf an EBGP peer is more than one hop away, a multihop BGP session must be established.
- DBGP devices require a direct connection to peer with each other.
Correct Answer:
C
C
send
light_mode
delete
Question #48
A route to the same destination is received from two different BGP sources.
Which criterion is considered first to determine the active BGP route?
Which criterion is considered first to determine the active BGP route?
send
light_mode
delete
Question #49
You are troubleshooting a BGP-learned prefix that is not being installed in the routing table.
Which command shows you the missing route?
Which command shows you the missing route?
- Ashow route advertising-protocol bgp
- Bshow route state
- Cshow route hidden extensive
- Dshow bgp summary
Correct Answer:
C
C
send
light_mode
delete
Question #50
You are asked to configure a new external BGP connection to a peer's loopback interface. You verify that the peer's loopback interface is reachable, but the BGP connection remains in Idle state.
Which BGP parameter is required to establish the BGP connection?
Which BGP parameter is required to establish the BGP connection?
send
light_mode
delete
All Pages