Nest 0 Cart
Nest Account
Popular Exams
All Categories...
Nest
Nest 0
Contact
Log In / Sign Up
Copyright 2024 © store. All rights reserved.
Home Dell DEA-5TT1

Dell DEA-5TT1 Exam Practice Questions (P. 5)

  • Full Access (61 questions)
  • Six months of Premium Access
  • Access to one million comments
  • Seamless ChatGPT Integration
  • Ability to download PDF files
  • Anki Flashcard files for revision
  • No Captcha & No AdSense
  • Advanced Exam Configuration
Get Contributor Access
Question #21
What is the default OSPF "hello interval"?
  1. A
    5 seconds
  2. B
    10 seconds
  3. C
    15 seconds
  4. D
    30 seconds

Correct Answer:
B

Question #22
Which port type should be used for only VLAN-unaware devices?
  1. A
    Access port
  2. B
    General port
  3. C
    Hybrid port
  4. D
    Trunk port

Correct Answer:
C

Question #23
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?
  1. A
    Switch
  2. B
    Transceiver
  3. C
    NIC
  4. D
    Port

Correct Answer:
B

Question #24
When configuring a switch, which CLI mode only supports limited show commands?
  1. A
    EXEC
  2. B
    Maintenance
  3. C
    Configuration
  4. D
    EXEC Privilege

Correct Answer:
A
Reference:
https://www.dell.com/support/manuals/us/en/04/poweredge-fx2/dell%20fn%20ioa%20config_9.8.0.0_pub-v1/cli-modes?guid=guid-aeb7d44d-2413-
4da8-b8b9-2f8a26bad435&lang=en-us

Question #25
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?
  1. A
    Manually specify the OSPF Router ID on each switch within the path.
  2. B
    Break the paths into multiple OSPF areas.
  3. C
    Change the reference speed used by OSPF in cost calculations on all switches within the path.
  4. D
    Switch all routing protocols to RIPv2.

Correct Answer:
C

Previous Questions Next Questions

All Pages