Cisco® 400-351 Exam Practice Questions (P. 2)
- Full Access (449 questions)
- Six months of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #11
_________ is classified as an 802.11i RSN with _________ as the mandatory encryption protocol.
send
light_mode
delete
Question #12
You are designing an autonomous wireless network for an office building that is located near a local airport. The customer requires the use of 802.11a/n clients only, and the APs must never change their channel after they are configured. Which two UNII bands and channels should you restrict the APs to use on the 5 GHz radios? (Choose two.)
- AUNII-1 and UNII-3
- BUNII-1 and UNII-2 extended
- C36-52 and 149-161
- D36-48 and 100-140
- E52-64 and 149-161
- F36-48 and 149-161
Correct Answer:
AF
AF
send
light_mode
delete
Question #13
You have been hired to install an outdoor wireless network for a small city. The design must provide 360 degrees of coverage from a central location and at least
33 Mb/s of aggregate bandwidth for clause 18 radio clients. How do you design this solution?
33 Mb/s of aggregate bandwidth for clause 18 radio clients. How do you design this solution?
- AThreeor more patch antennas installed in a circular pattern on the same supporting structure
- BOnehigh-gain omni-directional antenna
- CThreeor more parabolic dish antennas installed in a circular pattern on the same supporting structure
- DThreeor more sector array antennas installed in a circular pattern on the same supporting structure
- EThreeor more Yagi antennas installed in a circular pattern on the same supporting structure
Correct Answer:
D
D
send
light_mode
delete
Question #14
Which three security threats require the Cisco Adaptive wIPS service for mitigation? (Choose three.)
- Aon/off-channel rogue
- Bspectrum intelligence
- Cman-in-the-middle attack
- Drogue switch-port tracing
- Ezero-day attack
- Fnetwork reconnaissance
Correct Answer:
CEF
CEF
send
light_mode
delete
Question #15
Which of the following are required components for Client MFP? (Choose two.)
send
light_mode
delete
Question #16
Which of the following statements are true regarding RLDP? (Choose two)
- ARLDP works only on APs configured in Open Authentication mode.
- BRLDP only works if the AP is in Monitor Mode.
- CRLDP will attempt to identify each Rogue AP only once.
- DRLDP only works if the Rogue AP is connected to a VLAN that is reachable by the WLC.
- ERLDP only works if the AP is in Local Mode.
Correct Answer:
AD
AD
send
light_mode
delete
Question #17
Which of the following statements are not correct about Client Management Frame Protection (MFP)? (Choose 2.)
- AClient MFP can replace Infrastructure MFP in case only CCXv5 clients are used.
- BClient MFP encrypts class 3Unicastmanagement frames using the security mechanisms defined by 802.11i.
- CIn order to use Client MFP the client must support CCXv5 and negotiate WPA2 with AES-CCMP or TKIP.
- DThe only supported method to obtain the pre-user MFP encryption keys is EAP authentication.
- ECCXv5 client and access points must discard broadcast class 3 management frames.
Correct Answer:
AD
AD
send
light_mode
delete
Question #18
Corporation XYZ just underwent a third-party security audit. The auditors have required that the corporation implements 802.1x on its wireless network and disable all pre-shared key WLANs as soon as possible. XYZ does not have an internal CA installed to provide server certificates today. However, it wishes to implement an EAP method that requires clients to use server authentication in the future. XYZ also needs an EAP method that will allow both Active Directory user authentication and time-based tokens.
What is the best EAP method for XYZ to implement?
What is the best EAP method for XYZ to implement?
send
light_mode
delete
Question #19
Which of the below parameters are used in calculating the range - maximum distance - of an outdoor link between two bridges? Choose two.
- AThe cable length between bridge and the connecting switch.
- BThe bridge transmission power.
- CThe outside temperature.
- DThe modulation type.
- EThe length of the antenna.
Correct Answer:
BD
BD
send
light_mode
delete
Question #20
When viewed from the side (in the H-plane), how can the radiation pattern of a patch and Yagi antennas be described? (Choose two.)
- Athe patch patterns are egg-shaped.
- Bthe patch patterns are conical.
- Cthe patch patterns are doughnut-shaped.
- Dthe Yagi patterns are conical.
- Ethe Yagi patterns are egg-shaped.
- Fthe Yagi patterns are doughnut-shaped.
Correct Answer:
AD
AD
send
light_mode
delete
All Pages