Nest 0 Cart
Nest Account
Popular Exams
All Categories...
Nest
Nest 0
Contact
Log In / Sign Up
Copyright 2024 © store. All rights reserved.
Home Cisco® 300-360

Cisco® 300-360 Exam Practice Questions (P. 4)

  • Full Access (137 questions)
  • Six months of Premium Access
  • Access to one million comments
  • Seamless ChatGPT Integration
  • Ability to download PDF files
  • Anki Flashcard files for revision
  • No Captcha & No AdSense
  • Advanced Exam Configuration
Get Contributor Access
Question #16
Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)
  1. A
    Use the Cisco wireless phone site survey client utility.
  2. B
    Use a separate Cisco Wireless Lan Controller.
  3. C
    Enable load balance on voice WLANs.
  4. D
    Maintain -67dBM as a minimal RSSI.
  5. E
    Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
  6. F
    Enable lower data rates for 2.4-GHz data WLAN.

Correct Answer:
ADE

Question #17
An engineer is assigned to replace an older data-grade autonomous wireless network with a Cisco controller-based wireless network to meet Voice over WLAN needs. The customer also wants all existing cable infrastructure to be reused and no new cable be specified. How should the engineer respond to the customers requirements?
  1. A
    Implement the wireless network with the restraints and decrease the TPC neighbor threshold to increase Tx power to provide overlapping cell coverage at sufficient SNR to provide for Voice over WLAN service.
  2. B
    Implement the wireless network with the restraints and utilize high-gain antenna to provide overlapping cell coverage at sufficient SNR to provide for Voice over WLAN service.
  3. C
    Inform the customer that the network will not likely function as desired and a post install survey with the possibility of some new cable would be recommended.
  4. D
    Inform the customer that it is not possible to provide coverage and quality for Voice over WLAN using existing AP locations and an entire overbuild will be

Correct Answer:
B

Question #18
A Cisco 7925 phone at a clients location is not registering with CUCM. The engineer analyzes a packet capture, sees that the phone receives an IP, and downloads the proper configuration file from TFTP successfully. What type of messages should the phone be sending at this point?
  1. A
    H.245
  2. B
    H.323
  3. C
    MCGP
  4. D
    SCCP

Correct Answer:
D

Question #19
What are two advantages of conducting an active survey versus a passive survey when verifying RF coverage? (Choose two.)
  1. A
    verifies packet loss
  2. B
    verifies roaming
  3. C
    verifies SNR
  4. D
    verifies signal level
  5. E
    verifies interferers

Correct Answer:
AB

Question #20
An engineer is determining the signal levels for the wireless cells. Which signal-to-noise ratio is an optimal configuration to achieve?
  1. A
    minimum SNR of -33 dBm
  2. B
    minimum SNR of -25 dBm
  3. C
    minimum SNR of 25 dB
  4. D
    minimum SNR of 33 dB

Correct Answer:
C
The minimum recommended wireless signal strength for voice applications is -67 dBm and the minimum SNR is 25 dB.
Reference: http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/116057-site-survey-guidelines-wlan-00.html

Previous Questions Next Questions

All Pages