CWNP CWAP-405 Exam Practice Questions (P. 1)
- Full Access (60 questions)
- One Year of Premium Access
- Access to one million comments
- Seamless ChatGPT Integration
- Ability to download PDF files
- Anki Flashcard files for revision
- No Captcha & No AdSense
- Advanced Exam Configuration
Question #1
Which Spectrum Analyzer plot would show the percentage of time a signal is measured at a particular frequency?
send
light_mode
delete
Question #2
Explain the protocol behavior that can be known in the following graphic?
- ASingle Channel Architecture is in use.
- BThe data frames are missing because the capture adaptor does not support the PHY rate being used to transmit the data.
- COnly the CTS frames are being acknowledged. This indicates a problem with the wireless client.
- DOnly the CTS frames are being acknowledged. This is normal behavior.
send
light_mode
delete
Question #3
You have been hired to troubleshoot a WLAN problem for a government organization. You intended to use a Protocol Analyzer as part of your troubleshooting methodology; however, the customer is concerned about you capturing sensitive data transmitted over the network. Which common protocol analyzer feature could you use to address this concern?
send
light_mode
delete
Question #4
Your organization would like to give their network field engineers a tool to provide an overview of a given wireless LAN environment. They are interested in how many SSIDs are enabled per radio, channels used, and the number of APs per channel. They do not want to require the engineers to view multiple frames to determine the information. Which tool would you recommend that provides this information at the lowest cost?
- ASpectrum Analyzer
- BProtocol Analyzer
- CWLAN Scanner
- DSite Survey Software
send
light_mode
delete
Question #5
You are troubleshooting an intermittent problem with some WLAN VoIP phones resulting in dropped calls. You configure your capture on a fixed channel matching the current operating channel of a test phone. So far, you have been unsuccessful in capturing the problem because the VoIP phone always roams to another AP before the problem occurs.
What would be the best setup for your packet capture to make sure you capture the problem?
What would be the best setup for your packet capture to make sure you capture the problem?
- ADetermine which channel the phone is likely to roam to next and capture on that channel.
- BConfigure the capture adaptor to scan all channels used in the environment.
- CConfigure all APs in monitor mode and have the packets streamed back to your analyzer.
- DUse multiple capture adaptors and the channel aggregator feature of a protocol analyzer to capture on all AP channels in the client’s area.
send
light_mode
delete
All Pages
